1 thought on “How to add Poygen Mumbai Network to Metamask”
Marilyn
The method of adding is as follows: It you should add a pin to the principle gallery to correspond to that small pad, give it a network connected to it on the schematic diagram, and then import it. It can be connected normally. Is unconventional operation: Double -click the component in PCB to find the component attribute (P), the following locks the original check and remove, and then you can give you the Polygon and the small pad that you want alone. Modify to the network you want. Finally, do n’t forget to check the original locking back.
The method of adding is as follows:
It you should add a pin to the principle gallery to correspond to that small pad, give it a network connected to it on the schematic diagram, and then import it. It can be connected normally.
Is unconventional operation: Double -click the component in PCB to find the component attribute (P), the following locks the original check and remove, and then you can give you the Polygon and the small pad that you want alone. Modify to the network you want. Finally, do n’t forget to check the original locking back.