The method of adding is as follows: It you should add a pin to the principle gallery to correspond to that small pad, give it a network connected to it on the schematic diagram, and then import it. It can be connected normally. Is unconventional operation: Double -click the component in PCB to find the component attribute (P), the following locks the original check and remove, and then you can give you the Polygon and the small pad that you want alone. Modify to the network you want. Finally, do n’t forget to check the original locking back.
Your email address will not be published. Required fields are marked *
Save my name, email, and website in this browser for the next time I comment.